KoCoS Blog

Use of the Kelvin test probes KP 200 together with PROMET R300/R600

The KP 200 Kelvin test probes were developed for safe and easy resistance measurement at measuring points which are difficult to access. The test probe pair is equipped with spring-loaded high-current and voltage contacts for the determination of low-resistance according to the four-wire method for a test current of up to 200 A.


Can the test probes be used together with the PROMET R300 or R600 resistance meters?

The PROMET R300/R600 are designed with 13 mm high current sockets for the connection of 50 or 70 mm² high current cables. With the reducers 13/9 from 13 mm to 9 mm socket/plug diameter, it is possible to connect high-current cables with a smaller cross-section and 9 mm plugs or sockets to the PROMET R300/R600, such as the CS 205 cable set (2 x 5 m , 25 mm²).
With these cables it is now possible to use the KP 200 Kelvin test probes with the PROMET R300 or R600.


Furthermore, a measuring mode for the safe use of the KP 200 Kelvin test probes has been implemented in the stand-alone operation of the PROMET R300/R600 (from firmware version FWP 1.5).
According to the maximum load of the KP 200 Kelvin test probes, the current output in this mode is limited to 200 A.

If the measurement has started actively, the measuring device waits in this measuring mode for the test probes to be placed on the test object. A measurement is only carried out when the test probes are reliably and completely contacted (voltage and current contact). That is, the test current is output, the best measuring ranges are determined and the resistance value is measured. The measurement is carried out automatically with the shortest possible measurement time.

In order to simplify the use of the test probes on site, the current status of a measurement is also signaled by means of the LED status display and an acoustic signal.
The measurement result now remains on the display until the test probes are removed and the next measurement process is activated by placing the test probes. The resistance measurement results are displayed in a table and the results can be viewed before they can be saved.

With this sophisticated functionality, safe and automated operation of the KP 200 Kelvin test probes together with the PROMET R300/R600 resistance measuring devices is possible.

If you have further questions, please leave a comment or contact us directly.

Comments are disabled for this post.